CNC tube bender series
There are numerous industrial products made from metal tubes—such as automotive parts like brake tubes, air-conditioning tubes, seat structure components, fuel tubes, muffler tubes; aircraft and rocket engine tubes; tubing for home appliances like air conditioners, refrigerators, water heaters; as well as furniture structures like chairs, tables, and architectural materials. CNC tube benders perform the bending of these tubes.
Opton was the first in the world to develop a CNC (“Computer Numerical Control”) tube bender. We lineup products capable of bending tubes of various materials and sizes.
ST SeriesSupports 2D & 3D Bending
ST SeriesSupports 2D & 3D Bending
Our best-selling, most widely-used bender.
We offer a variety of models tailored to the tube being bent.
As a guide, it excels at bending when the bend radius is 1.5 times or more the tube diameter.
Main Processed Products
Automotive parts
Heat exchanger tubing
Air-conditioning tubing
Agricultural machinery parts
Construction machinery parts
Semiconductor manufacturing equipment tubing
Exterior (handrails, wheel stops)
Interior (office furniture, store fixtures)
ST-H-15
Car Air Conditioning Pipe
Room Air Conditioning Pipe
Gas Appliance Piping
Architectural Hardware
Resin-Coated Handrail
UD SeriesSupports 0.7D & 1.5D Bending
UD SeriesSupports 0.7D & 1.5D Bending
A high-spec bender that covers the performance of the ST series and additionally enables processing of thin-walled tubes and ultra-small bend radii (0.7 times the tube diameter).
We offer a variety of models tailored to the tube being bent.
Main Processed Products
Architectural hardware (e.g., door handles)
Fluid tubing
U-shaped tubing for heat exchangers
Automotive exhaust tubing
UD-T-100
Water Supply Piping
Air Conditioning Piping
Motorcycle Parts
Exhaust Manifold
Intake Manifold
SW Series
SW Series
Achieved single-chuck processing even for products that would cause interference if only right or only left bending were used.
Only the SW series can process 3D bending products with symmetrical shapes.
The newly developed vertical-bending SWV series has also debuted. It allows for up to four types of dies to be set at both ends of the bending unit, developed with a concept designed for the shop floor to reduce die changeover to half or less. In addition to switching bending directions, it offers low interference in overhead space and reduced setup time.
The H-type is fully NC-controlled, environmentally friendly, compact, and meets the needs of the current generation of tube processing equipment.
Main Processed Products
Automotive interior parts
Stabilizers
Office furniture
Symmetrically-bent parts
SW-T-50
Headrest
Piping for Heat Exchange
Stabilizer
Cart Handle
Uniaxial Series
Uniaxial Series
A bender stabilized for long-term, high-precision repeatability through CNC numerical control.
Main Processed Products
U-shaped tubing for heat exchangers
Automotive intake and exhaust tubing
Air-conditioning tubing
ST-U-15
Hydroforming Pre-Bend
Truck Exhaust Pipe
Compressor Piping
Exhaust Components
B Type
Excels at bending when the bend radius is 1.5 times or more the tube diameter.
U Type
Capable of processing thin-walled tubes with ultra-small bend radii (0.7–1.5 times the tube diameter).
Mainly used for fine tubes and processing with ultra-small bend radii, such as automotive air-conditioning.
Mainly used for 180-degree U-shaped bending, such as for heat exchangers.
Inquiries about Products
Please wait for a while until the form is shown.
Sorry, if you can not see the form even if you wait for a while, please contact Here.